|
Technical parameters |
Value |
|
Output |
Ethernet |
|
Measured Value |
Temperature + Relative Humidity + Atmospheric Pressure |
|
Construction Type |
With T+RH Probe on Cable |
|
Design |
Industrial |
|
Temperature Measuring Range |
-30 to 105 °C |
|
Relay Output |
Yes |
|
Two-State Input |
Yes |
|
Lcd Display |
Yes |
|
PoE |
No |
|
Relative humidity range |
0 to 100% |
|
Accuracy of relative humidity measurement |
±2.5% relative humidity from 5 to 95% at 23°C |
|
Accuracy of temperature output |
±0.4°C |
|
Maximum measuring pressure range |
600 to 1100hPa |
|
Accuracy |
±1.3hPa at 23°C |
|
Resolution |
0.1°C, 0.1%RH, 0.1hPa |
|
Measuring interval |
2s |
|
Available temperature units |
degrees Celsius, degrees Fahrenheit |
|
Computed value |
humidex, dew point, absolute humidity, specific humidity, mixing ratio, specific enthalpy |
|
Available pressure units |
hPa, kPa, mbar, mmHg, inHg, inH2O, PSI, oz/in2 |
|
Accuracy and range of dew point temperature output - for more details see graphs in manual |
±1.5°C at ambient temperature T<25°C and RH>30%
range -60 to +80°C |
|
Accuracy and range of absolute humidity output |
±1.5g/m3 at ambient temperature T < 25°C
range 0 to 400g/m3 |
|
Accuracy and range of specific humidity output |
±2g/kg at ambient temperature T < 35°C
range 0 to 550g/kg |
|
Accuracy and range of mixing ratio output |
±2g/kg at ambient temperature T < 35°C
range 0 to 995g/kg |
|
Accuracy and range of specific enthalpy output |
±3kJ/kg at ambient temperature T < 25°C
range: 0 to 995 kJ/kg |
|
Temperature compensation of the humidity sensor |
all temperature range |
|
Temperature operating range |
-30 to +80°C |
|
IP protection |
IP40 |
|
Number of relay outputs |
2 |
|
Maximum switching voltage, current and power of relay output |
50V, 2A, 60VA |
|
Number of binary inputs |
3 |
|
Signal for binary inputs |
dry contact, open collector or two-state voltage signal.
Inputs are not galvanically isolated. |
|
Minimum pulse length at binary input |
500ms |
|
Low voltage level |
0 to +0.5V |
|
High voltage level |
+3.0 to +30V |
|
Audible alarm |
built-in beeper - switchable |
|
LAN connection |
RJ-45 connector, 10Base-T or 100Base-TX |
|
Communication protocols |
WWW, ModbusTCP, SNMPv1, SOAP, XML |
|
Alarm protocols |
E-mail (SMTP authentication is supported), SNMP Trap, Syslog |
|
Configuration |
WWW interface, T-Sensor |
|
Temperature operating range of LCD display |
readable to operating temperature +70°C, it is recommended to switch OFF the LCD over +70°C |
|
Filtering ability of sensor cover |
0.025mm - filter with stainless steel mesh |
|
Power |
9 to 30Vdc, maximum consumption 1W |
|
Power connector |
co-axial, diameter 5.5 x 2.1mm |
|
Length of the probe cable |
1m, 2m or 4m optionally |
|
Dimensions |
136 x 159 x 45mm (W x H x D), probe length 88mm, probe diameter 18mm |
|
Weight |
approximately 410g - 1m probe |
